2 Color Paracord Bracelet Instructions With Buckle

Then Singe The Frayed Part Of The String.

In this tutorial i demonstrate how to tie the belly fishtail paracord bracelet. Throughout this instructable i will show you how to make a 2 color survival bracelet with a buckle. After the bracelet is cut to the correct length, cauterize the ends of the paracord with a lighter so that they don’t fray and unravel your bracelet.

To Make The Job Simpler, You Should First.

If you have a paracord needle, run the ends back into the weave, then cut and melt. First measure 6 ½ inches (this is just smaller than your wrist size) of loop in the. (about 1 ft of paracord for every 1 inch of bracelet length).

Attach The Female Part At The Bottom Of Your Weaving Apparatus Or Setup.

Place the male piece at the top of the loom; Release the buckle and lay the bracelet out with one cord to each side and the middle two cords parallel down the middle. Push the loops snugly toward the male buckle & pull the loose ends tight.

Then Take The Second Piece Of.

We are now beginning to start tying the bracelet. Kissmi 8 pack paracord bracelet survival gear with compass, fire starter, whistle and emergency…. Pull the ends through until the loop is the size of your wrist.

Unbuckle It And Keep Both Parts Separated.

5 feet (1.5m) of paracord in another color* 2 1/2 feet (75cm) of paracord in whatever color scissors lighter optional: Click here for 550 paracord. Pinch the cord and detach the buckle.